Enable networking
- In order to access the public internet, you will need an Exit Node. See Tailscale Exit Nodes for detailed instructions.
- Note: This is not required to access machines in your own Tailscale Network.
- Depending on your network speed, you may need to wait a few moments for the Tailscale Wasm module to be downloaded.
When all set:
- Log in with your Tailscale credentials.
- Go back to the WebVM tab.
- The
Connect to Tailscale button in the Networking side-panel should be replaced by your IP address.
Log in to Tailscale with an Auth key
- Add
#authKey=<your-key> at the end of the URL.
- Done, you don’t need to manually log in anymore.
It is recommended to use an ephemeral key.
Log in to a self-hosted Tailscale network (Headscale)
- Add
#controlUrl=<your-control-url> at the end of the URL.
- You can combine this option with
authKey with a &: #controlUrl=<url>&authKey=<key>.